NOTE! After years in service and our stock runs out, this timer will no longer be available by the manufacturer. HOPEFULLY NOT TRUE BECAUSE THIS TIMER HAS BEEN A GREAT TIMER.  This high-quality OEM timer is 2 3/4" square by 1 5/8" deep. Great to use with a low voltage power source from 6 to 24V AC or DC.  If used with the Super-Feeder (some wiring required), just push one small tab per feed cycle like any of the 120V analog timers.  The Super Feeder needs 12 to 24 volts AC or DC.  Driven by quartz controlled stepper motor (1 second in 24 hr accuracy! This model will loose time if disconnected from its power source, but easy to reset (just move the hands). Program disc with 144 switch actuators (10 min. tabs). Programmable for 20 minutes on-off intervals. Extremely simple and fast setting. Indication of switch-on period by red disc section and connection by trip-tab terminals. Time of day is very visible via the hands on the dial. The whole dial is covered with removable clear lens. Set time of day and weekday (7-day type) by rotating a center glass panel. Easy programming by moving the switch actuators. Its current draw is next to none at 1.9 milliamp. Single-pole-double-throw (one normally closed and other normally open) switch rating is 16 Amps/250V BASICALLY, THIS TIMER CAN GIVE YOU UP TO 3 ON-OFF cycles per hour and 72 PER 24 HOURS! EASY MOUNTING: JUST OPEN THE ENCLOSURE, CONNECT WIRES TO SCREW TERMINALS, RUN THEM THOUGH PUNCH-OUT PLUGS (BACK OR BOTTOM), AND MOUNT BOX WITH 2 SCREWS THROUGH BACK WALL OR USE DOUBLE-STICK TAPE. TIMER MUST BE WELL SHELTERED IF USED OUTDOORS. STILL NOT SURE ABOUT WHAT IT WILL DO? CALL US AT 615-470-5596 OR E-MAIL AT info@super-feed.com

NOTE: THIS ELECTRONICS ITEM IS NOT RETURNABLE AFTER USE. YOU WILL NEED YOUR OWN POWER SOURCE, i.e. 12V battery, etc...